I’m aware that Leah strongly discourages using CH341a, but I understand that this is chiefly because it’s voltage is 5V, whiich risks burning the 1.8V or 3.3V datalines of the devices we’re librebooting.

At the same time, I’ve seen a popular video specifically recommending CH341a when librebooting an X200. I assume this advice should be ignored.

However, Leah also specifies that you can technically tweak the CH341a to reduce it’s voltage, following this guidance.

My question is: is this worth it, or is it safer to just use a Beaglebone Black/Raspbery Pi instead? What’s your experience been?

I’m unfortunately on a budget, and BB/RPi are both prohibitively expensive for me. Then again, so is a laptop that’s bricked thanks to an improperly fixed CH341a.

Have you had problems using a (tweaked or untweaked) CH341a? What’s your advice? I really appreciate it. Thanks!

  • timkenhan@sopuli.xyz
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    You’d only need to plug the power in and connect the 3v3 & ground to the chip. I was only mentioning this because then you’d never have to set the voltage and a lot of people have it laying around. Otherwise, any DC power supply would do as long as you can get that 3.3v output.